Other Name: Unit Sub-Assembly, Radiator; HVAC Heater Core, Rear; Unit Sub-Assembly, Heater Radiator; HVAC Heater Core
Position: Rear
Replaces: 87107-48100
Fits the following Toyota Models:
Highlander | 2008-2019 | Base, Hybrid, Hybrid LE, Hybrid Limited, Hybrid Limited Platinum, Hybrid XLE, LE, LE Plus, Limited, Limited Platinum, Plus, SE, Sport, XLE | 4 Cyl 2.7 L GAS, 6 Cyl 3.3 L FULL HYBRID EV-GAS (FHEV), 6 Cyl 3.5 L FULL HYBRID EV-GAS (FHEV), 6 Cyl 3.5 L GAS
Q: How to Service and Repair the Heater Core in a Rear Heating Unit on Toyota 4Runner?
A: Engine coolant draining marks the first step of rear heater unit repair work but technicians should not empty all the coolant from the system. The first service stage requires frontend seats removal together with the center console box followed by floor carpet rearward adjustment. During installation position the hose clip according to the provided illustration before removing the water hoses. First disconnect the rear heater duct by removing its bolt and screw and duct before removing the rear heater control assembly. To unscrew the rear heater duct start by disconnecting its connectors then take out the three screws which fasten the heater unit. Rear/transverse engine vehicles employ the exact reverse sequence during installation of removed components.
Q: How to service the heater core on Toyota Camry?
A: Draining the radiator coolant begins the heater core service procedure yet a full coolant depletion is not needed. Subsequent to disconnecting the water hoses from the A/C unit you should take out the No.1 lower instrument panel along with the LH instrument lower panel. Start by releasing the 3 claws from the heater protector then pulling it out and afterward removing the 3 screws on the plate. The removal of the heater radiator begins with unscrewing the 2 clamps on the pipes and removing the screws before extracting the heater radiator. The reverse procedure is used for heater radiator installation.
Q: How to service and repair the heater core on Toyota Corolla?
A: The procedure for servicing and repairing a heater core starts by first removing the air duct through unscrewing and using a taped screwdriver to open its five claws for extraction. The next step involves cover removal through the release of 2 claws using a screwdriver which should have its tip taped for protection. Remove the heater radiator by unscrewing the clamp and screw followed by pulling it out. The heater radiator installation should start with screw and clamp application before adding the cover and finishing with screw installation for the air duct.