The first step to install the 2WD rear sway bar kit starts with bushing installation on the LH side followed by identical steps for the RH side. Begin the installation of rear No. 1 sway bar bracket by attaching it first to the LH side then move on to the RH side. Install the rear sway bar kit by applying 4 bolts while tightening them to 19 Nm (194 kgf-cm, 14 ft-lbf). The installation of the rear sway bar link assembly LH to the rear
Shock Absorber with coil spring LH requires a nut torque of 39 Nm (400 kgf-cm, 29 ft-lbf). When the ball joint turns with the nut application, use a 5-mm hexagon wrench to grip the stud bolt. The installer should perform this procedure again on the right-hand rear sway bar link assembly. Continue by installing the rear wheels while tightening them to achieve 103 Nm of torque equivalent to (1050 kgf-cm, 76 ft-lbf).