Mount the sway bar bush on the outside portion of the stopper ring installed on the sway bar kit. The installation requires the application of 8 sway bar kit bolts which should reach 19 Nm (195 kgf-cm, 14 ft-lbf) of torque when installing 2 sway bar bushes and 4 sway bar brackets. Pay close attention to which type of bolts (A or B) is needed due to their different specifications. When installing components on convertibles it begins with the center floor panel reinforcement sub-assembly LH and RH secured with 4 bolts using Torque: 56 Nm (571 kgf-cm, 41 ft-lbf). The member brace rear lower LH and RH follows with 4 bolts (Bolt B - Torque: 56 Nm (571 kgf-cm, 41 ft-lbf) and Bolt C - Torque: 51 Nm (520 kgf-cm, 38 ft-lbf)) then ends with the floor panel brace rear installed by 2 bolts (Bolt D - Torque The rear sway bar link assembly LH needs two nuts to attach while torqueing up to 39 Nm (400 kgf-cm, 29 ft-lbf). During this process use a hexagon wrench (5 mm) to prevent the ball joint from turning with the nut. Reinstall the rear sway bar link assembly RH by using the same installation method. Put the rear wheel into place before tightening it with 103 Nm of torque (1,050 kgf-cm, 76 ft-lbf).