Other Name: Sensor, Speed, Front Right-Hand; ABS Wheel Speed Sensor, Front Right, Rear Right; Speed Sensor; Front and Rear Passenger Side Speed Sensors.
Position: Front Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2018-2022 Toyota Sequoia | Limited, Nightshade, Platinum, SR5, TRD Pro, TRD Sport | 8 Cyl 5.7 L FLEX, 8 Cyl 5.7 L GAS
Other Name: Sensor, Speed, Front Right-Hand; Front Speed Sensor; Sensor, Speed, Front Passenger Side
Manufacturer Note: AUTO LEVELER & HEIGHT CONTROL-WITH
Position: Front Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2023-2024 Toyota Sequoia | Capstone, Limited, Platinum, SR5, TRD Pro | 6 Cyl 3.4 L FULL HYBRID EV-GAS (FHEV)
| Page 1 of 2 |Next >
1-20 of 21 Results
Toyota Sequoia Speed Sensor
If you're thinking about purchasing OEM parts for your Toyota Sequoia, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Sequoia Speed Sensor at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Sequoia Speed Sensor Parts Questions & Experts Answers
Q: How to service and repair the speed sensor on Toyota Sequoia?
A: Vehicle speed sensor service begins by disconnecting the No. 1 sensor connector then taking out its bolt for removal. The No. 1 vehicle speed sensor disassembly requires you to extract the O-ring from the speed meter driven gear assembly before removing the clip and speed meter driven gear from the speed meter driven gear sleeve. The speed meter driven gear sleeve assembly requires installation of its components before placing a new ATF-coated O-ring in position. Meet the following requirements to install the No. 1 vehicle speed sensor: use a bolt and torques it to 16 Nm (160 kgf-cm, 12 ft. lbs.) before reattaching its connector. Start by disassembling the No. 2 vehicle speed sensor through bolt removal and disconnecting its connector. After that remove the O-ring from it. Apply AT on the new O-ring before installing the O-ring onto the No. 2 vehicle speed sensor unit. The no. 2 speed sensor should be fastened using 5.4 Nm (55 kgf cm) and 48 inch lbs torque before connecting its cable.