OEM 2010 Scion xD Knock Sensor

2010 Scion xD Parts Questions & Experts Answers

• Q: How to install the knock sensor and complete the assembly process on 2010 Scion xD?

  A: The knock sensor needs to be secured using a 21 Nm (214 kgf-cm, 16 ft-lbf) torque settings for the bolt followed by connection of the knock sensor connector. You must install a new gasket on the intake manifold then attach the intake manifold and intake manifold stay with four bolts and two nuts secured at 28 Nm (286 kgf-cm, 21 ft-lbf). Finally, assemble the water by-pass hose with the No. 2 water by-pass hose. After connecting these components you should proceed to link the throttle body assembly connector with the ventilation hose and the four wire harness clamps. The maintenance process includes fitting the transmission oil level gauge sub-assembly and the oil cooler tube while installing the engine oil level dipstick and the starter assembly. After setting up the flywheel housing side cover the injector vibration insulator and the No. 1 delivery pipe spacer you should install the fuel delivery pipe sub-assembly. The installation process requires engineers to join together the fuel tube sub-assembly with the fuel pipe clamp and vacuum hose and the No. 1 fuel vapor feed hose. The series of installation begins with the harness bracket and the engine wire harness before moving on to install the air cleaner cap sub-assembly with hose. The battery cable installation requires a torque of 5.4 Nm (55 kgf-cm, 48 in-lbf) applied to the negative terminal. After that, add engine coolant before conducting leak inspections. Place the No. 2 cylinder head cover and secure the engine under covers on both right and left sides with 5.0 Nm (51 kgf-cm, 44 in-lbf) torque.