OEM 2008 Toyota Sequoia Neutral Safety Switch

2008 Toyota Sequoia Neutral Safety Switch Parts Q&A

• Q: How to install the Park/Neutral Safety Switch Assembly for the A750F Automatic Transmission/Transaxle on 2008 Toyota Sequoia?

  A: The Park/Neutral Position Switch Assembly for the A750F Automatic Transmission/Transaxle installation starts with attaching the switch to the manual valve shaft before installing the bolt temporarily. Fix a new lock washer together with nut before tightening it to 6.9 Nm (70 kgf-cm, 61 in-lbf). The control shaft lever RH requires temporary installation before adjusting its rotation counterclockwise until stopping then proceeding clockwise by two notches to correctly position the N setting against the neutral basic line. At position keep the switch under control while steadily tightening the bolt to 10 ft-lbf (133 kgf-cm or 13 Nm). After that use a screwdriver to bend the lock washer tabs. The transmission control shaft lever RH with spring washer and nut needs installation while tightening the components to 16 Nm (163 kgf-cm, 12 ft-lbf) before connecting the switch connector. Connect the transmission control cable assembly starting with its cable and nut with 14 Nm strength and verify the cable L bracket points toward the interior of the vehicle. End the procedure by checking and readjusting the shift lever when required.