OEM 2009 Toyota Sequoia Neutral Safety Switch

2009 Toyota Sequoia Parts Questions & Experts Answers

• Q: How to install the Park/Neutral Safety Switch Assembly for the A750E Automatic Transmission/Transaxle on 2009 Toyota Sequoia?

  A: The Park/Neutral Position Switch Assembly installation for A750E Automatic Transmission/Transaxle begins by attaching the switch to manual valve shaft and putting a securing bolt in place temporarily. Place a new lock washer and nut before tightening it so that the torque reaches 6.9 Nm (70 kgf-cm, 61 in-lbf). Place the control shaft lever RH into position and adjust its rotation to the N spot until it stops at counterclockwise then turn it clockwise two notches before fixing the groove in line with the neutral basic line. Tighten the bolt against the switch position to a torque of 13 Nm and apply the screwdriver to bend the tabs of the lock washer. Install the transmission control shaft lever RH with its spring washer and nut according to the torque measurements of 16 Nm (163 kgf-cm, 12 ft-lbf), then connect the switch connector. Cutoff the transmission control cable with the nut while guiding its L bracket inside the vehicle framework before fastening it to 14 Nm (143 kgf-cm, 10 ft-lbf).