OEM 2007 Toyota Sequoia Neutral Safety Switch

2007 Toyota Sequoia Neutral Safety Switch Parts Q&A

• Q: How to service and repair the Park/Neutral Safety Switch on 2007 Toyota Sequoia?

  A: The park/neutral position switch service requires disconnecting the switch connector followed by using a tool to remove the assembly by undoing the lock washer then removing the nut while taking out the bolt and the switch. You should adjust the park/neutral position switch bolt by moving the shift lever to N position while lining up the switch groove with the neutral basic line. Then secure the switch in place and tighten the bolt to 13 Nm (1,130 kgf-cm, 10 ft. lbs.). To install the park/neutral position switch bolt must be tightened to 13 Nm (1,130 kgf-cm, 10 ft. lbs.). Subsequently, a new lock washer and nut should be added before torquing the nut to 6.9 Nm (70 kgf-cm, 61 inch lbs.) while staking the nut by bending the washer claws. You must adjust the park/neutral position switch followed by reconnecting the park/neutral position switch connector.