The windshield washer installation process begins by mounting the rear washer motor together with its pump onto the washer jar packing. Installation of the windshield washer motor and pump should occur with their placement on the washing jar packing. The windshield washer jar and pump assembly requires 3 screws installed at 5.0 Nm (51 kgf-cm, 44 in-lbf) torque then reception of 3 connectors and 2 washer hoses to washer motor and pumps before clamping installation. Washer fluid should be added to the washer jar. Front bumper cover installation requires the proper installation procedure unless it has an under guard which needs installation first. The installation process should include putting on the radiator support opening cover. Fit the left front fender liner while incorporating its clip and fender liner retainer but attach the front fender splash front shield LH after securing it with screw, nut, and bolt. The right fender liner installation requires the same procedures. Affix the washer inlet sub-assembly onto the windshield washer jar and pump by using a clip for installation. Connect the cable to the negative battery terminal as the last step.