The front sway bar kit installation process starts with placing front No. 1 sway bar bush LH on its inner side of bush stopper with the slit positioned toward the vehicle's rear end. Use the method from Step 4 to uninstall the front No. 1 sway bar bush RH before proceeding with installation. Begin sway bar kit installation by placing the front No. 1 sway bar bush LH on its inner bush stopper with the slit facing the rear before fastening it with 4 bolts torqued to 87 Nm (887 kgf-cm, 64 ft-lbf). The installation of both front suspension member brace front components requires following the same procedure. Put 2 nuts on the front sway bar link assembly LH and secure them at 74 Nm (755 kgf-cm, 55 ft-lbf) then install the front sway bar link assembly RH with the same methodology. Put on the front wheel before performing a braking torque procedure to 103 Nm (1,050 kgf-cm, 76 ft-lbf).