Install the LH side rear No. 1 suspension arm assembly by first temporarily attaching the suspension arm with bolt and 2 nuts fastened to the suspension member and axle carrier. First tighten the rear wheel with 103 Nm (1,050 kgf-cm, 76 ft-lbf). The final tightening of the rear No. 1 suspension arm assembly requires the nut and 2 bolts installation followed by bolt torque to 90 Nm (918 kgf-cm, 66 ft-lbf) and nut torque to 100 Nm (1,020 kgf-cm, 74 ft-lbf). Keep the nut on the rear suspension member side loose. Finished work involves checking and modifying the wheel alignment if needed.