Other Name: Knuckle, Steering, Right; Steering Knuckle, Front Right, Right; Knuckle, Steering, Passenger Side
Position: Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2009-2013 Toyota Matrix | S, XRS | 4 Cyl 2.4 L GAS
Toyota Matrix Steering Knuckle
If you're thinking about purchasing OEM parts for your Toyota Matrix, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Matrix Steering Knuckle at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Matrix Steering Knuckle Parts Questions & Experts Answers
Q: How to remove the steering knuckle on Toyota Matrix?
A: Steering knuckle removal begins by taking off the front wheel and front Axle Shaft nut on both 2AZ-FE and 2ZR-FE engines. The front axle shaft nut should be removed on both 2AZ-FE engines and 2ZR-FE engines. You must detach the front Speed Sensor and the front disc brake caliper assembly. Take the front disc out after performing its removal. The front tie rod end sub-assembly should be separated for 2WD vehicles while 4WD vehicles require identical steps. Start by separating the front lower suspension arm and afterward proceed with the front axle assembly removal. Secondly, remove the front lower Ball Joint while you proceed to take out the front axle hub hole snap ring and front axle hub sub-assembly. The disc brake dust cover must be taken off before concluding with steering knuckle removal. The front axle hub bearing removal process requires the front axle hub bearing inner race (outside) to be placed against the front axle hub bearing when using the combination of Special Service Tool: 09527-17011, 09950-60010, and a press to extract the front axle hub bearing from the steering knuckle with assistance from Special Service Tool: 09951-00640 and 09951-07100, 09950-70010 when necessary.