Other Name: Sensor, Air Bag, Front; Air Bag Impact Sensor, Front; Air Bag Sensor; Front Sensor; Sensor, Air Bag, Front Passenger Side; Sensor, Air Bag, Front Driver Side
Manufacturer Note: MARK=89173-75010
Position: Front
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Sensor, Side Air Bag; Air Bag Impact Sensor, Center, Front; Air Bag Sensor; Side Sensor; Sensor Assembly, Side Air Bag, Passenger Side; Sensor Assembly, Side Air Bag, Driver Side
Position: Center
Replaces: 89831-42010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Sensor, Air Bag, Front; Air Bag Impact Sensor, Front Right, Right; Air Bag Sensor; Front Impact Sensor; Front Sensor; Sensor, Air Bag, Front Passenger Side
Position: Front Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Sensor, Air Bag, Front; Air Bag Impact Sensor, Front; Air Bag Sensor; Front Sensor; Sensor, Air Bag, Front Passenger Side; Sensor, Air Bag, Front Driver Side
Manufacturer Note: DENSO
Position: Front
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Sensor, Air Bag, Front; Air Bag Impact Sensor, Front Left, Left; Air Bag Sensor; Front Impact Sensor; Front Sensor; Sensor, Air Bag, Front Driver Side
Position: Front Driver Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2004-2006 Scion xB | Base | 4 Cyl 1.5 L GAS
Scion xB Air Bag Sensor
If you're thinking about purchasing OEM parts for your Scion xB, our website is your one-stop destination. We stock an extensive selection of genuine Scion xB Air Bag Sensor at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Q: How to replace the Air Bag Sensor Assy Center on Scion xB?
A: In order to change the Air Bag Sensor Assy Center, un screw the battery negative terminal and take off the bottom center panel. Take out the sensor with T40 torx wrench. Use 4 screws to install the new sensor in 20 Nm torque making sure that there is no damage or interference with SRS wiring. Check the SRS warning light and check connections.
A: In order to install the Air Bag Sensor Front LH, disconnect the negative terminal of the battery and remove the front RH sensor. Make sure the Ignition Switch is switched off and allow 90 seconds until you install the new sensor using 2 bolts, 17.5 Nm tightness. Before testing the SRS warning light, check for any defects and make sure it is installed properly.