OEM 2009 Toyota Sienna Spark Plug

2009 Toyota Sienna Spark Plug Parts Q&A

• Q: How to remove the spark plugs on 2009 Toyota Sienna?

  A: The first step to remove spark plugs from 2GR-FE ignition starts with disconnecting the cable from the negative battery terminal and then removing engine coolant. Start by removing the wiper arm head cap from the front along with the wiper arms located on both the right and left sides. You must remove first the windshield wiper motor as well as the cowl top ventilator louver sub-assembly then the windshield wiper motor link assembly. Begin the sequence by taking out the inner part of cowl brace No. 1 and then removing the front component of the cowl top panel sub-assembly. You should start by taking off the No. 1 engine under cover as well as the V-bank cover sub-assembly and move on to the air cleaner cap sub-assembly and finally the intake air surge tank assembly. The removal process of No. 1 surge tank stay requires removal of 2 bolts along with a nut followed by harness clamp disconnect and bolt removal with No. 1 surge tank stay extraction.Context: number of steps to remove. Start by removing the right and left right wiper arms, then proceed to remove the cowl top ventilator louver subassembly and the windshield wiper motor along with its link assembly. Next, remove the No. 1 cowl top to cowl brace inner and the cowl top panel sub-assembly outer front. Afterwards, take out the No. 1 engine under cover, the In the final step disconnect the 6 ignition coil connectors before removing the 6 bolts together with ignition coils which leads to the removal of 6 spark plugs.