OEM 2007 Toyota Solara ABS Control Module

2007 Toyota Solara ABS Control Module Parts Q&A

• Q: How to service and repair the ABS Control Module for Antilock Brakes on 2007 Toyota Solara?

  A: The Hydraulic Control Assembly for Antilock Brakes requires fluid drainage before repair work starts while cleaning all painted areas affected by fluid. Begin by disconnecting the battery negative terminal after removing the brake actuator with bracket through the release of the connector latch and application of Special Service Tool to disconnect the 6 brake tubes with proper notation of reconnection points. You should carefully detach the brake actuator with bracket through the removal of 3 bolts while ensuring the brake tubes and wire harness remain undamaged. You must remove the brake actuator from the bracket by unfastening its 2 nuts. To install the brake actuator place it onto the bracket by applying two nuts which should be torqued to 8.0 N.m (82 kgf.cm, 71 in.lbf). Users must install the brake actuator along with bracket by adding 3 bolts which require 19 N.m (194 kgf.cm, 14 ft.lbf) torque setting before using Special Service Tool to connect each brake line at its appropriate position on the brake actuator while torquing to 15 N.m (155 kgf.cm, 11 ft.lbf). Connect the brake actuator connector after which brake fluid should be added to the reservoir followed by a bleeding process of the brake master cylinder sub-assembly along with the brake line. Verify the reservoir fluid level alongside checking for any brake fluid leaks after connecting the negative battery terminal. The intelligent tester should be used to verify brake actuator functionality.