OEM 2007 Toyota Solara Air Bag

2007 Toyota Solara Parts Questions & Experts Answers

• Q: What are the essential service procedures to follow for the Air Bag system to prevent accidental deployment or failure on 2007 Toyota Solara?

  A: All Air Bags in the Supplemental Restraint System (SRS) of the vehicle come with front passenger Air Bags and driver Air Bags and side Air Bags and curtain shield Air Bags and following the proper service procedures will stop accidental deployments while ensuring SRS functionality. Service operations must not begin until after waiting 90 seconds while the ignition switch is set to LOCK and the negative (-) battery terminal cable is disconnected because the SRS system possesses an onboard power source. All SRS components that include steering pad and Air Bag assemblies and sensors need to stay away from exposure to both hot air and open flames. It is essential to check DTCs prior to battery removal while performing inspections on SRS parts after any traffic incident regardless of Air Bag activation. SRS components always require fresh parts and must never be removed from their vehicle or repaired because any signs of damage necessitate replacement without reusing original components. The assessment of electrical components requires a volt/ohmmeter with minimum impedance of 10 kohms/V and the safe usage of SRS component warnings found near their location. It is essential to check SRS warning lights and document system memories before removing the battery because this procedure clears the memory recording. After reconnecting the negative (-) battery cable it is necessary to conduct an initial power window control system (for Coupe) and sliding roof system set-up. The replacement or adjustment of any Air Bag sensor component should wait 90 seconds after the negative (-) terminal cable disconnection. Connect the Air Bag sensor connectors correctly while never using any sensors which have previously fallen to the ground. The correct procedures should be followed to properly attach and detach SRS connectors with locks through the usage of screwdrivers and complete insertion until an audible click indicates proper engagement.