OEM 2006 Toyota Solara ABS Control Module

2006 Toyota Solara Parts Questions & Experts Answers

• Q: How to Service the ABS Control Module in Antilock Brakes on 2006 Toyota Solara?

  A: Service and repair of the Hydraulic Control Assembly for Antilock Brakes involves fluid drainage followed by quick paint surface washing of residual fluid droplets. First disconnect the battery negative terminal before removing the brake actuator with bracket through the brake actuator connector latch along with Special Service Tool: that disconnects 6 brake tubes and notates all reattachment points. Insulate the brake tubes before removing the 3 bolts that secure the brake actuator along with its bracket. Use proper tools to remove the brake actuator from its bracket by removing first the two nuts. The first step for installation involves pushing the brake actuator onto the bracket while adding the 2 nuts with 8.0 N.m (82 kgf.cm, 71 in.lbf) torque specification followed by attaching the bracket to the actuator with 3 bolts and torquing them to 19 N.m (194 kgf.cm, 14 ft.lbf). Be cautious of the brake tubes and wire harness throughout the process. Once the brake lines are in position on the brake actuator Special Service Tool: should be used to torque them at 15 N.m (155 kgf.cm, 11 ft.lbf) before reconnecting the brake actuator connector. The service procedure requires filling the reservoir with brake fluid followed by subassembly bleeding using Special Service Tool: 09023-00101 and continued bleeding of the brake line. It is essential to check brake fluid leakage then verify the reservoir level before reconnecting the battery negative terminal. The intelligent tester needs to be used to check the brake actuator.