OEM 2005 Toyota Solara ABS Control Module

2005 Toyota Solara ABS Control Module Parts Q&A

• Q: How to replace the ABS Control Module on 2005 Toyota Solara?

  A: The replacement procedure for Brake Actuator Assembly (W/ VSC) requires draining brake fluid and wiping off paint-contacted liquid immediately. You should disconnect the battery negative terminal and then remove the brake actuator with bracket through the use of Special Service Tool: 09023-00101 to detach the 6 brake tubes while making notes of their reconnection locations. The replacement of the actuator with bracket starts with locking the lever and disconnecting the actuator connector while extracting the 3 bolts to remove the unit carefully to prevent damage of brake tubes and wire harness. First detach the brake actuator assembly from the brake actuator bracket through removing its 2 nuts. You should install the brake actuator assembly by tightening two nuts to 5.4 Nm (55 kgf-cm, 48 inch lbs.) before installing the actuator with bracket using the three bolts to a torque specification of 19 Nm (194 kgf-cm, 14 ft. lbs.) while maintaining safe distance from brake tubes and wire harness. Connect the actuator connector before you apply Special Service Tool: 09023-00101 to attach brake tubes correctly to the actuator with bracket while torquing them to 15 Nm (155 kgf-cm, 11 ft. lbs.). After filling the brake fluid reservoir you should use the special tool 09023-00101 to bleed master cylinder systems before proceeding to bleeding of brake lines. Check for brake fluid leakages while confirming the reservoir fluid level before attaching the battery negative terminal back. Other systems must be initialized first and then the yaw rate sensor requires zero point calibration and a hand-held testing process for brake actuators.