The first task is removing the front wheel to access the front lower suspension arm of a 2WD vehicle. You can check the lower
Ball Joint of the front suspension lower arm by putting hub nuts on the disc while using a dial indicator to measure excessive play when you apply 294 N (30 kgf, 66 lbf) force; replace the lower arm if the play exceeds 0.5 mm (0.020 in.). The front stabilizer link assembly removal is followed by front
Shock Absorber with coil spring separation through bolt removal and washer disassembly and nut removal. The procedure to remove the front suspension lower arm requires 2 bolt removal to disconnect the front lower ball joint attachment from the front axle and matchmarks on the camber adjust cam No. 2 along with removal of the 2 nuts and both No. 2 and No. 1 camber adjust cams and the front suspension lower arm. Special Service Tool: 09628-00011 should be used to detach front lower ball joint attachment while removing the nut and cotter pin. You should finish the procedure by taking out the front spring bumper.