OEM Toyota Solara Oil Filter

Toyota Solara Oil Filter Parts and Q&A

• Oil Filter
  90915-YZZF1
  Q: How to replace the oil and oil filter on Toyota Solara?

  A:

  Begin by wearing protective clothing and gloves along with gloves to prevent skin exposure to mineral oil since it can trigger dermatitis along with irritation. Keep in mind that used engine oil comprises hazardous substances. Start by draining engine oil through the removal of the oil filler cap and the oil drain plug until the oil completes its journey into a storage container. After cleaning and changing the drain plug gasket install it with 25 Nm (255 kgf-cm, 18 ft. lbs.) torque. To begin prepare the oil filter sub-assembly removal using Special Service Tool: 09228-06501 followed by cleaning the oil filter installation surface before applying engine oil to the gasket. Use Special Service Tool: 09228-06501 to thread the oil filter partly into position without resistance and complete the installation with three additional turns. While finishing the procedure install a new oil filler cap after adding fresh oil until the engine oil capacity reaches its specification. End the process by letting the engine reach normal operating temperature and verifying any signs of oil leakage. Thorough emotion-related waste disposal must occur exclusively at sites meant for these materials.
• Oil Filter
  90915-YZZD1
  Q: How to service the oil filter safely and effectively on Toyota Solara?

  A:

  Before servicing the oil filter take safety measures to protect yourself from mineral oil exposure because it leads to skin dryness and dermatitis conditions along with its contaminant content. The suspension of protective gear with gloves protects users during service and washing with soap water should occur immediately after contact with mineral oil. Clear areas have been established for proper disposal of contaminated oil and filters. The service starts with draining engine oil through removal of the oil filler cap followed by the oil drain plug until the collected oil reaches a designated container. To remove the oil filter sub-assembly you must install Special Service Tool: 09228-06501 onto the oil filter before extracting it from the assembly. To install a new oil filter start by cleaning the mounting surface and applying clean engine oil to its gasket before screwing it lightly to reach the seat and finishing with an additional 3/4 turn while using Service Tool: 09228-06501. Proceed to install the fresh new oil drain plug using a new gasket then torque it to 25 Nm (255 kgf-cm, 18 ft. lbs.) and refill the engine with fresh oil before installing the oil filler cap. The last step should be to verify there are no oil leaks from the engine.