Other Name: Sensor, Speed, Front Right-Hand; ABS Wheel Speed Sensor, Front Right; Front Speed Sensor; ABS Sensor Wire; Sensor, Speed, Front Passenger Side
Position: Front Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2019-2022 Toyota Avalon | Hybrid Limited, Hybrid XLE, Hybrid XSE, Hybrid XSE Nightshade, Limited, XLE, XSE, XSE Nightshade | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS, 6 Cyl 3.5 L GAS
Other Name: Sensor, Transmission; Vehicle Speed Sensor
Manufacturer Note: (L)
Replaces: 89413-33030
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2008-2010 Toyota Avalon | Limited, Touring, XL, XLS | 6 Cyl 3.5 L GAS
| Page 1 of 2 |Next >
1-20 of 25 Results
Toyota Avalon Speed Sensor
If you're thinking about purchasing OEM parts for your Toyota Avalon, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Avalon Speed Sensor at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Avalon Speed Sensor Parts Questions & Experts Answers
Q: How to service and repair the front wheel speed sensor on Toyota Avalon?
A: The first step towards serving or repairing the front wheel speed sensor requires you to take out both the front wheel and the front fender liner LH. To detach the speed sensor harness from body and Shock Absorber assembly start by disconnecting both the speed sensor connector and clamp before eliminating the 2 bolts. The first step involves uninstalling the bolt on the steering knuckle then unclamping the front speed sensor with removal procedures that include cleaning both the hole and surface after each uninstallation. During installation the front side LH speed sensor should be installed while using a bolt with a torque setting of 8.0 N.m (82 kgf.cm, 71 in.lbf) and protect the sensor tip from foreign particle contact. Secure sensor harness brackets using two bolts where they connect to the body and shock absorber assembly at proper torque values of 5.0 N.m (51 kgf.cm, 44 in.lbf) and 19 N.m (192 kgf.cm, 14 ft.lbf). Place the clamp on the steering knuckle without distorting the wire harness for the front LH speed sensor and then connect the speed sensor connector. The procedure ends with reinstalling the front fender liner LH and front wheel followed by torquing the wheel to 103 N.m (1,050 kgf.cm, 76 ft.lbf). Afterward, inspect the ABS speed sensor signal once without VSC and once with it.