OEM Scion TPMS Sensor

Scion TPMS Sensor Parts Questions & Experts Answers

• Warning Switch
  84746-30010
  Q: How to remove the TPMS Sensor and Transmitter on Scion tC?

  A: The first step to uninstall the Tire Pressure Warning Valve and Transmitter requires users to remove both front and rear wheels from the vehicle. You must first leave air out of the tire by taking off the valve core and cap before removing the nut and washer holding the tire pressure warning valve and transmitter so they can fall into the tire. Save all Tire Pressure Warning Valve and Transmitter hardware including caps, valves, cores, nuts, and washers because they will be needed for reassembly. Place the valve and transmitter inside the tire while the tire bead is disengaged but take caution to prevent damage to the valve and transmitter from encountering the tire bead. Remove both tire beads normally before pulling out the tire pressure warning valve and transmitter. Afterward, finish the bead removal on the lower rim. First inspect the grommet for fractures or breakage then get a new one if the inspection shows damage.
• Tire Pressure Sensor, Driver Side
  84746-AE010
  Q: How to remove the TPMS Sensor and Transmitter on Scion xD?

  A: The first step for removal of Tire Pressure Warning Valve and transmitter requires wheel removal from both the front and the rear. First remove tire air through valve core removal followed by the disassembly of the tire pressure warning valve and transmitter nut and washer so the parts will fall into the tire. The user should retain both removde valve core and valve cap. Lower the valve and transmitter inside the tire and then use the tire remover shoe to loosen the bead while being cautious of transmitter and valve damage from coming into the tire bead. Start by lowering the bead on the upper portion and extract the tire pressure warning valve and transmitter before taking the bead off the lower side in its customary fashion. The replacement of the grommet should be performed even if no signs of damage appear.
• TPMS Sensor
  42607-33012
  Q: How to remove the TPMS Sensor and Transmitter on Scion xB?

  A: The first step for Tire Pressure Warning Valve and Transmitter extraction requires front and rear wheel removal. You must first release pressure from the tire by taking off its valve core and cap before disconnecting the wheel pressure warning valve and transmitter nut with its washer for complete valve entry into the tire. Recommends the retention of any removed tire valve core and plastic cap. You need to drop the valve and transmitter into the tire but you should do it after removing the tire bead through the shoe without allowing damage to the valve or transmitter from the tire bead. Continue by removing the bead from the upper side according to standard procedure and extract the tire pressure warning valve and transmitter before lowering the bead on the lower side through normal process. The entire set of grommet along with washer and nut should be removed whether or not the grommet shows signs of damage.