OEM 2010 Scion xB Sway Bar Kit

2010 Scion xB Sway Bar Kit Parts Q&A

• Q: How to install the front Sway Bar Kit and related components on 2010 Scion xB?

  A: Start by attaching the front sway bar bush labeled No. 1 so its dust lips extend outward and cutouts point toward the rear on both left and right sides of the bar. The front sway bar kit installation requires putting it onto the front suspension crossmember sub-assembly with its identification mark facing the right side. Use 4 bolts to install the front suspension member front brace LH where bolt A gets a temporary touching before tightening in sequence B, C, D, A, then finalize by torquing the bolts to 87 Nm (887 kgf-cm, 64 ft-lbf) and additionally ensure you can see the No. 1 front sway bar bushing protrusion. Install the front suspension member front brace RH by using 4 bolts and torque them to 87 Nm (887 kgf-cm, 64 ft-lbf) while following the installation sequence of B, C, D, and A. Check that the No. 1 front sway bar bushing protrusion is visible. Workers must first attach the front lower No. 1 suspension arm sub-assembly LH before which they should install the front suspension crossmember sub-assembly then put on the front suspension member brace rear LH and RH according to the same installation steps for both sides. The front suspension member reinforcement LH and RH installation should be followed by front lower No. 1 suspension arm sub-assembly LH and RH connection and subsequent tie rod end sub-assembly LH and RH connection which needs to be done identically on both sides. Connect the front sway bar link assembly LH and RH after which attach the No. 1 steering column hole cover sub-assembly, the No. 2 steering intermediate shaft assembly, and the column hole cover silencer sheet. Finish engine under cover installation with the engine under cover rear RH followed by engine under cover rear LH then No. 2 engine under cover until the last piece is the No. 1 engine under cover followed by front wheel installation. Adjust the suspension while you completely tighten the front lower No. 1 suspension arm sub-assembly LH before inspecting and adjusting the front wheel alignment.