OEM 2009 Toyota Camry Knock Sensor

2009 Toyota Camry Knock Sensor Parts Q&A

• Q: How to install the knock sensor and related components on 2009 Toyota Camry?

  A: Mount the knock sensor using a nut after positioning it properly before connecting its connector. Install the intake manifold gasket after which you must insert the intake manifold using 5 bolts and 2 nuts tightened to 30 Nm (306 kgf-cm, 22ft-lbf). Install the vacuum hose clamp around the check valve union before connecting the camshaft timing oil control valve connector to its wire harness. The same step follows by attaining the check valve union to the brake booster hose. Implement the fuel delivery pipe with injector and then install the fuel tube followed by the throttle body then place the air cleaner case sub-assembly and the air cleaner cap sub-assembly before installing the air cleaner inlet assembly. After connecting the negative terminal cable you must add engine coolant while inspecting for leaks of fuel and engine coolant. Position the No. 1 engine cover sub-assembly before installing the cowl top panel outer sub-assembly through 4 bolts connected to 4 nuts that require 5.0 Nm (51 kgf-cm, 44in-lbf) bolt torque and 85 Nm (867 kgf-cm, 44ft-lbf) nut torque. The installation process concludes with the windshield wiper motor and link as well as the cowl top ventilator louver sub-assembly and front fender to cowl side seals (also RH and LH) and windshield wiper arm and blade assemblies (LH and RH).