OEM 2008 Toyota Prius Vapor Canister

2008 Toyota Prius Vapor Canister Parts Q&A

• Q: How to install the Vapor Canister with the pump module on 2008 Toyota Prius?

  A: The first step to install the Evaporative Emission Control Canister with pump module begins with attaching the fuel tank vent hose by guiding the connector into the pipe until the connector clicks with the assurance of a scratch-free and debris-free connection area. The hose connector must be checked for proper installation through a connector pull test. Place a new gasket onto the fuel tank before inserting the trap canister with pump module by avoiding gasket drop. Fasten the trap canister along with the pump module against the fuel tank wire ground terminal through 2 bolts which should have a torque of 6.0 Nm (61 kgf-cm, 53 in-lbf). The fuel tank vent hose tube installation starts with securing it to 2 No. 1 fuel tubing by grommet clamps followed by clamping both the fuel tank vent hose and canister hose beneath. After connecting the canister pump module connector you should install the fuel tank vent hose onto the 2 No. 1 fuel tube through grommet clamps. The installation process entails connecting the fuel tank tube to its corresponding canister tube before performing the same operation for the fuel tank main tube with its proper clamp. After cable attachment to the negative battery terminal, examine for fuel leakage then verify exhaust gas integrity before installing the front floor panel brace along with all rear-related components including the service hole cover, seat cushion assembly, center finish panel, and floor boards both deck and No. 2. Before ending your work you must perform initialization because some systems need this process after the negative cable disconnect and reconnect.