Other Name: Motor Assembly, Power Window Regulator; Motor, Center Left, Front Left, Rear Left, Rear Right; Door Lock Actuator; Motor; Power Window Regulator Assembly for Front Driver, Passenger, and Driver Side.
Replaces: 85720-35140
Item Weight: 1.30 Pounds
Item Dimensions: 7.4 x 4.6 x 4.3 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 85720-AE010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Motor Assembly, Power Window Regulator; Center Right, Front Right, Rear Left, Rear Right, Right; Motor; Power Window Regulator Assembly for Front Passenger, Driver, and Passenger Side.
Replaces: 85710-35180
Item Weight: 1.30 Pounds
Item Dimensions: 7.7 x 4.7 x 4.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 85710-AE010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Motor Assembly, Power Window Regulator; Power Window Motor, Front Left, Rear Right; Door Lock Actuator Motor; Motor Assembly, Power Window Regulator, Passenger Side; Driver Side; Power Window Motor
Replaces: 85720-58010
Item Weight: 1.40 Pounds
Item Dimensions: 8.0 x 5.8 x 2.7 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 85720-AE020
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Scion xD Submodels:
Base | 4 Cyl 1.8 L GAS
2008 Scion xD Window Motor
Looking for affordable OEM 2008 Scion xD Window Motor? Explore our comprehensive catalogue of genuine 2008 Scion xD Window Motor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2008 Scion xD Parts Questions & Experts Answers
Q: How do you install the rear Window Motor assembly on 2008 Scion xD?
A: Apply MP grease to the sliding and rotating areas of the regulator motor before using a TORX socket wrench T25 to fasten the front power window regulator motor assembly with 3 screws at 5.4 Nm (55 kgf-cm, 48 in-lbf) torque level. The sequence for installation includes first putting on the rear door window regulator sub-assembly then adding the rear door glass sub-assembly. In the installation process of the rear door window division bar sub-assembly install 2 bolts and a screw by following a torquing sequence of 6.2 Nm (63 kgf-cm, 54 in-lbf) and then attach the rear door Weather Strip. Beginning with the rear door glass run installation proceed to service hole cover then trim bracket before completing the trim board sub-assembly setup and installing the inside handle bezel followed by the armrest base upper panel. The front power window regulator motor assembly requires application of MP grease to sliding and rotating parts before installing it with 3 TORX T25 screws which should be torqued to 5.4 Nm (55 kgf-cm, 48 in-lbf). Add and install the front door window regulator sub-assembly, front door glass sub-assembly, service hole cover, trim bracket, trim board sub-assembly, inside handle bezel, lower frame bracket garnish and armrest base upper panel. Last, attach the cable to the negative battery terminal before tightening it to 5.4 Nm (55 kgf-cm, 48 in-lbf).