Other Name: Motor Assembly, Power Window Regulator; Motor, Center Left, Front Left, Rear Left, Rear Right; Door Lock Actuator; Motor; Power Window Regulator Assembly for Front Driver, Passenger, and Driver Side.
Replaces: 85720-35140
Item Weight: 1.30 Pounds
Item Dimensions: 7.4 x 4.6 x 4.3 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 85720-AE010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Motor Assembly, Power Window Regulator; Center Right, Front Right, Rear Left, Rear Right, Right; Motor; Power Window Regulator Assembly for Front Passenger, Driver, and Passenger Side.
Replaces: 85710-35180
Item Weight: 1.30 Pounds
Item Dimensions: 7.7 x 4.7 x 4.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 85710-AE010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Scion xB Submodels:
Base | 4 Cyl 2.4 L GAS
2008 Scion xB Window Motor
Looking for affordable OEM 2008 Scion xB Window Motor? Explore our comprehensive catalogue of genuine 2008 Scion xB Window Motor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2008 Scion xB Window Motor Parts Q&A
Q: How to remove the Window Motor from both the RH and LH sides on 2008 Scion xB?
A: The first step to extract both power window regulator motors is disconnecting the negative battery terminal cable. Start by taking off the series of components including the front armrest base upper panel, front door lower frame bracket garnish, front door inside handle bezel, front door trim board sub-assembly, front door trim bracket, and front door service hole cover and front door glass sub-assembly. When replacing the front power window regulator motor assembly you must first use a "TORX" socket wrench T25 to remove all 3 screws securing the motor assembly. Step following this is to remove the front door window regulator sub-assembly together with the front power window regulator motor assembly. Prerequisite steps for accessing the rear door involve disassembly of the rear door armrest base upper panel followed by removal of the rear door inside handle bezel, rear door trim board sub-assembly, rear door trim bracket and rear door service hole cover, rear door glass run. After detaching the rear window Weather Strip you can reach the rear door window division bar bolts and screw to remove them safely. The sequence requires removal of the rear door quarter window Weather Strip followed by the rear door glass sub-assembly before dismantling the rear door window regulator sub-assembly and finishing with the removal of the rear power window regulator motor assembly using the same "TORX" socket wrench T25 to take out the 3 screws.