Other Name: Plate, Back Door Name; Hatch Emblem, Rear; Plate, Luggage Compartment Door Name
Manufacturer Note: YARIS
Position: Rear
Part Name Code: 75442
Item Weight: 0.50 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 75442-52210
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2007 Toyota Yaris Submodels:
Base, S | 4 Cyl 1.5 L GAS
2007 Toyota Yaris Emblem
Looking for affordable OEM 2007 Toyota Yaris Emblem? Explore our comprehensive catalogue of genuine 2007 Toyota Yaris Emblem. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2007 Toyota Yaris Emblem Parts Q&A
Q: How to service and repair the Emblem for the sedan on 2007 Toyota Yaris?
A: The name plate servicification requires removal of the front bumper cover initial step which starts with disconnecting the negative battery cable (Fog Light present) and following with the front spoiler took (Front Spoiler option exists). Uninstalling the front spoiler requires removing five screws and three bolts, two screw grommets, along with six clips although other sedan models would require seven screws, three bolts, two screw grommets and six clips. Models with fog lights require users to first disconnect two fog light connectors as well as remove six claws before removing the front bumper cover. Fourth, remove the radiator grille emblem by unfastening 4 claws from their position. A heat treatment with an infrared light at 40 to 60 degrees Celsius (104 to 140 degrees Fahrenheit) should be applied to the No. 6 luggage compartment door name plate before adhesive tape goes on. C (104 to 140 degrees Use an infrared light heated to 40 to 60 degrees Celsius (104 to 140 degrees Fahrenheit) for 1 to 2 minutes before carefully removing the name plate with a gasket scraper which is covered by protective tape. The same placement procedure must be followed for the No. 2 luggage compartment door name plate and symbol emblem after cleaning the attachment surfaces with non-residue solvent and removing any double-sided adhesive tape. Install the new symbol emblem by correctly placing the pins and maintain an ambient temperature greater than 20 degrees Celsius (68 degrees Fahrenheit). C (68 degrees Heat the panel along with the emblem to 20-30 degrees Celsius (68 to 86 degrees Fahrenheit) to proceed. C (68 to 86 degrees Fahrenheit). Clear the surfaces of each position for the No. 2 and No. 6 luggage compartment name plates before installing them. The last step involves proper installation of the radiator grille emblem by using the 4 claws followed by front bumper cover replacement after fog light connector reconnection then securing it with suitable clip and screw and bolt components. After completing the last installation steps re-attach the front spoiler cover (w/ Front Spoiler) while tightening the cable to the negative battery terminal (w/Fog Light) with 5.4 N.m (55 kgf.cm, 48 in.lbf).