The installation of the symbol emblem begins with heating the double-sided adhesive tape on the luggage compartment door panel through an infrared light at 40 to 60 degrees Celsius (104 to 140 degrees Fahrenheit) for 1 to 2 minutes. During this time, remove the tape with a shop rag while maintaining heat for preventing adhesion failure. The first step involves cleaning the surface with a non-residue solvent after which you should align the pins while installing the new symbol emblem in a space of at least 20 degrees Celsius (68 degrees Fahrenheit); heating both components to 20 to 30 degrees Celsius (68 to 86 degrees Fahrenheit) becomes necessary when operating in sub-20 degrees Celsius (68 degrees Fahrenheit) environments. Use the exact cleaning methods to remove all adhesive from the No. 2 luggage compartment door name plate before installing it under the same temperature environment. The replacement protocol for the name plate on the No. 6 luggage compartment door matches other procedures. The installation process of the radiator grille emblem requires using 4 claws. Connect 2 fog light connectors if present then click the 6 claws to fit the front bumper cover while a front
Spoiler needs installation of 6 clips combined with 2 screw grommets that should be followed by tightening 5 screws and 3 bolts or if no spoiler exists tighten 7 screws and 3 bolts. The installation process ends by removing protective tape while connecting the cable to the negative battery terminal that requires a torque setting of 5.4 Nm (55 kgf-cm, 48 in-lbf).