OEM 2007 Toyota Yaris Antenna Cable

2007 Toyota Yaris Antenna Cable Parts Q&A

• Q: How to service the Radio Antenna Cable for the Hatchback 5 Door on 2007 Toyota Yaris?

  A: Service of the Radio Antenna Cord on the Hatchback 5 Door starts with disconnecting the negative battery cable and waiting 90 seconds to avoid Air Bag activation. You must first detach the rear seat before removing the deck board sub-assembly, deck floor boxes (RH and LH), and No. 1 and No. 2 rear seat leg covers for the 60/40 Split Seat Type with a "Torx" socket wrench E10. Remove the rear seat assemblies (RH and LH), rear seat cushion cover pad sub-assembly, rear seatback assembly, rear deck trim cover, front door scuff plates (RH and LH), instrument panel under cover sub-assemblies (RH and LH), cowl side trim boards (RH and LH), front and rear door opening trim Weather Strips, rear seat outer belt assemblies (RH and LH), deck trim side panel assemblies (RH and LH), roof side inner garnishes (RH and LH), seat belt anchor cover caps, front seat outer belt assemblies (RH and LH), center pillar garnishes (upper and lower, RH and LH), and the assist grip sub-assembly and cover. The team must first separate the visor assemblies with their holders from the RH and LH sides before removing the room light assembly and map light assembly as well as instrument panel finish panel ends on both the RH and LH sides and the instrument cluster finish panel and combination meter assembly and glove compartment door assembly separately from the No. 1 switch hole base. The removal process of the No. 2 antenna cord sub-assembly starts with unbolted bracket removal and connector and plug detachment while using a clip remover to release the clamp and three antenna cord holding clamps. Start by removing the roof headlining assembly while disconnecting the antenna cord from the clamp and connectors and then unfasten the antenna cord sub-assembly being cautious to strip off a proper tape count according to curtain shield Air Bag presence. Installation occurs in the opposite sequence by properly connecting the antenna cord through new tape pieces before hook installation followed by roof headlining application and connector connection and the No. 2 antenna cord sub-assembly installation with clamps. After finishing all operations remove all parts keeping the process backward from installation steps and then attach the connector wire to the negative terminal while applying force of 5.4 N.m (55 kgf.cm, 48 in.lbf) followed by SRS warning light examination.