OEM 2008 Toyota Yaris Antenna Cable

2008 Toyota Yaris Parts Questions & Experts Answers

• Q: How to remove the RADIO ANTENNA CABLE for the Sedan on 2008 Toyota Yaris?

  A: One must begin RADIO ANTENNA CORD removal on Sedan vehicles by cutting off the negative battery cable and waiting at least 90 seconds to stop the Air Bag from activating. The procedure for RADIO ANTENNA CORD removal starts with the Rear Seat cushion cover pad sub-assembly before it moves to the removal of both RH and LH Rear Seatback assemblies. The process ends with the Luggage compartment floor mat followed by the Spare wheel cover assembly and Luggage compartment trim inner pad. A removal of the rear seatback assembly represents the required step for vehicles equipped with Fixed Seat Type. Next, remove the front door scuff plates (RH and LH), instrument panel under cover sub-assemblies (RH and LH), cowl side trim boards (RH and LH), front door opening trim Weather Strips (RH and LH), rear door scuff plates (RH and LH), rear door opening trim Weather Strips (RH and LH), rear seat side covers (RH and LH), roof side inner garnishes (RH and LH), center pillar lower garnishes (RH and LH), seat belt anchor cover cap, front seat outer belt assemblies (RH and LH), center pillar upper garnishes (RH and LH), front pillar garnishes (RH and LH), instrument panel lower center finish panel, instrument panel finish panel ends (RH and LH), instrument cluster finish panel, combination meter assembly, glove compartment door assembly, upper instrument panel sub-assembly, and instrument cluster center finish panel sub-assembly (except Integrated with Panel). The next step involves extracting the RADIO RECEIVER ASSEMBLY and ANTENNA CORD SUB-ASSEMBLY where you need to remove the bolt, hook, bracket while using a clip remover to detach the clamp before disconnecting the antenna amplifier connector and removing the 5 clamps along with the antenna cord. You must remove the assist grip cover and sub-assembly as well as visor assemblies (RH and LH), visor holders (RH and LH), room light assembly, map light assembly and roof headlining assembly by using a clip remover to detach the clamp and disconnecting the antenna connector. To remove the roof headlining you must detach the 2 clips then separate all 4 hooks or if no Curtain Shield Air Bag is present detach the 2 clips then disengage 2 claws and 4 hooks. The removal process concludes with taking off the NO. 2 ANTENNA CORD SUB-ASSEMBLY by removing tape and disengaging it from the claws associated with front and rear side real spacers according to Curtain Shield Air Bag installation.