How to service and repair the side Air Bag sensor on 2007 Toyota Tacoma?

Service and repair work on the side Air Bag sensor starts with following appropriate rules for restraint system operations. The negative battery cable must be disconnected for 90 seconds of stand time to avoid Air Bag activation. Start service and repair of the side Air Bag sensor by removing front door scuff plate LH, rear door scuff plate LH, front door opening trim Weather Strip LH, rear door opening trim Weather Strip LH, lap belt outer anchor cover, and center pillar lower garnish LH. Remove the side Air Bag sensor through the process of partial bolt removal and disconnecting its connector. All installation steps require following two conditions: a battery negative terminal disconnected for ninety seconds plus an OFF position of the ignition switch. Caulke the side Air Bag sensor into the fixture with a bolt then tighten it to 9.0 N.m (80 kgf.cm, 80 in.lbf). Install the connector while the sensor assembly remains in position and check for any assembly damage; replace the assembly if there is damage. Verify that no restrictions exist between the SRS wiring and other system components or any pinching points. The sensor assembly must be secured by shaking it after setup and you must verify all installation components lack looseness before linking the connector to the side Air Bag sensor. The service technician needs to replace the center pillar lower garnish LH with a lap belt outer anchor cover and rear door opening trim Weather Strip LH beside the front door opening trim Weather Strip LH before installing the rear door scuff plate LH and front door scuff plate LH. During reinstallation complete the connection to the negative battery terminal while applying 3.9 N.m (40 kgf.cm, 35 in.lbf) torque force followed by checking the SRS warning light.

OEM 2007 Toyota Tacoma Air Bag Sensor

Air Bag Impact Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Air Bag Sensors found

View related parts
2007 Toyota Tacoma Front Impact Sensor
Part Number: 89173-09270
$102.25 MSRP: $123.29
You Save: $21.04 (18%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Air Bag, Front; Air Bag Impact Sensor, Front; Air Bag Sensor; Front Sensor; Sensor, Air Bag, Front Passenger Side; Sensor, Air Bag, Front Driver Side
- Position: Front
- Replaces: 89173-09280
- Item Weight: 0.70 Pounds
- Item Dimensions: 4.6 x 2.9 x 2.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89173-09270
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
More Info
Fits the following 2007 Toyota Tacoma Submodels:
- Base, Pre Runner, X-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 4.0 L GAS
View related parts
2007 Toyota Tacoma Position Sensor, Passenger Side
Part Number: 89178-06030
$79.26 MSRP: $111.27
You Save: $32.01 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Seat Position; Seat Track Position Sensor, Front/Right/Left; Air Bag Seat Sensor Mat; Occupant Detection Sensor; Air Bag Sensor; Occupant Sensor; Sensor, Seat Position Air Bag
- Position: Passenger Side
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.0 x 1.6 x 1.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89178-06030
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
More Info
Fits the following 2007 Toyota Tacoma Submodels:
- Base, Pre Runner, TRD Pro, X-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 4.0 L GAS
View related parts
2007 Toyota Tacoma Position Sensor, Passenger Side
Part Number: 89178-06020
$79.26 MSRP: $111.27
You Save: $32.01 (29%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Seat Position; Seat Track Position Sensor, Left, Right; Air Bag Sensor; Occupant Sensor; Seat; Sensor, Seat Position Air Bag
- Position: Passenger Side
- Part Name Code: 89178A
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.1 x 1.6 x 1.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89178-06020
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
More Info
Fits the following 2007 Toyota Tacoma Submodels:
- Base, Limited, Pre Runner, SR, SR5, Trail, Trail Special Edition, TRD Off-Road, TRD Pro, TRD Sport, X-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 4.0 L GAS
View related parts
2007 Toyota Tacoma Side Impact Sensor, Front
Part Number: 89831-02040
$103.08 MSRP: $124.29
You Save: $21.21 (18%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Side Air Bag; Air Bag Impact Sensor, Front, Upper; Air Bag Sensor; Side Sensor; Sensor Assembly, Side Air Bag, Passenger Side; Sensor Assembly, Side Air Bag, Driver Side
- Position: Front
- Item Weight: 0.60 Pounds
- Item Dimensions: 4.2 x 2.6 x 2.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89831-02040
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
More Info
Fits the following 2007 Toyota Tacoma Submodels:
- Base, Pre Runner, X-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 4.0 L GAS
View related parts
2007 Toyota Tacoma Rear Sensor
Part Number: 89831-04020
$98.34 MSRP: $118.58
You Save: $20.24 (18%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Side Air Bag; Air Bag Impact Sensor, Rear; Air Bag Sensor; Side Impact Sensor; Side Sensor; Sensor, Air Bag, Rear Passenger Side; Sensor, Air Bag, Rear Driver Side
- Position: Rear
- Item Weight: 0.60 Pounds
- Item Dimensions: 4.3 x 2.7 x 2.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89831-04020
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
More Info
Fits the following 2007 Toyota Tacoma Submodels:
- Base, Pre Runner, X-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 4.0 L GAS
View related parts
2007 Toyota Tacoma Position Sensor, Driver Side
Part Number: 89178-0W010
$79.26 MSRP: $111.27
You Save: $32.01 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Seat Position; Seat Track Position Sensor, Left; Air Bag Sensor; Seat; Sensor, Seat Position Air Bag
- Position: Driver Side
- Part Name Code: 89178A
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.1 x 1.6 x 1.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89178-0W010
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
More Info
Fits the following 2007 Toyota Tacoma Submodels:
- Base, Pre Runner, TRD Pro, X-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 4.0 L GAS

2007 Toyota Tacoma Air Bag Sensor

Looking for affordable OEM 2007 Toyota Tacoma Air Bag Sensor? Explore our comprehensive catalogue of genuine 2007 Toyota Tacoma Air Bag Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!

2007 Toyota Tacoma Air Bag Sensor Parts Q&A

Q: How to service and repair the side Air Bag sensor on 2007 Toyota Tacoma?
A: Service and repair work on the side Air Bag sensor starts with following appropriate rules for restraint system operations. The negative battery cable must be disconnected for 90 seconds of stand time to avoid Air Bag activation. Start service and repair of the side Air Bag sensor by removing front door scuff plate LH, rear door scuff plate LH, front door opening trim Weather Strip LH, rear door opening trim Weather Strip LH, lap belt outer anchor cover, and center pillar lower garnish LH. Remove the side Air Bag sensor through the process of partial bolt removal and disconnecting its connector. All installation steps require following two conditions: a battery negative terminal disconnected for ninety seconds plus an OFF position of the ignition switch. Caulke the side Air Bag sensor into the fixture with a bolt then tighten it to 9.0 N.m (80 kgf.cm, 80 in.lbf). Install the connector while the sensor assembly remains in position and check for any assembly damage; replace the assembly if there is damage. Verify that no restrictions exist between the SRS wiring and other system components or any pinching points. The sensor assembly must be secured by shaking it after setup and you must verify all installation components lack looseness before linking the connector to the side Air Bag sensor. The service technician needs to replace the center pillar lower garnish LH with a lap belt outer anchor cover and rear door opening trim Weather Strip LH beside the front door opening trim Weather Strip LH before installing the rear door scuff plate LH and front door scuff plate LH. During reinstallation complete the connection to the negative battery terminal while applying 3.9 N.m (40 kgf.cm, 35 in.lbf) torque force followed by checking the SRS warning light.