OEM 2007 Toyota Prius ABS Control Module

2007 Toyota Prius ABS Control Module Parts Questions & Experts Answers

• Q: How to service the ABS Control Module on 2007 Toyota Prius?

  A: Before accessing the ABS Control Module service you must disconnect the cable from the negative battery terminal while waiting at least 90 seconds to avoid Air Bag and seat belt pretensioner activation. Start by following steering column assembly service procedures which include the removal methods for No 2. rear floor board up to the steering column assembly. The skid control ECU removal process starts with removing the wire harness clamp and skid control buzzer from its bracket before disconnecting the 4 ECU connectors and unthreading its 3 retaining nuts. Installation of the skid control ECU requires 3 nut tightening to 5.0 N.m (51 kgf.cm, 44 in.lbf) while reconnecting its 4 connectors followed by reattaching the wire harness clamp and skid control buzzer onto the skid control ECU bracket. Install the steering column assembly by using the procedures for steering column installation until you reach the step of mounting No 2. rear floor board. Follow the removal of the negative battery cable by checking the SRS warning light and starting system initialization because some systems need this procedure following cable installation and removal. Conduct brake system initialization routines and then calibrate the yaw rate sensor zero point. You must conclude by verifying and erasing all DTCs.