Other Name: Belt Assembly, Rear Seat; Seat Belt Lap and Shoulder Belt, Rear Left Outer, Rear Right Outer; Outer Belt Assembly; Rear Seat 3 Point Type, Outer Passenger & Driver Side.
Manufacturer Note: GREGE,TRIM4#
Position: Rear
Item Weight: 2.00 Pounds
Item Dimensions: 12.1 x 11.2 x 8.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 73360-47041-E0
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2007 Toyota Prius Submodels:
Base, Touring | 4 Cyl 1.5 L FULL HYBRID EV-GAS (FHEV)
Other Name: Belt Assembly, Rear Seat; Seat Belt Lap and Shoulder Belt, Rear Left Outer, Rear Right Outer; Outer Belt Assembly; Rear Seat 3 Point Type, Outer Passenger & Driver Side.
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2007 Toyota Prius Submodels:
Base, Touring | 4 Cyl 1.5 L FULL HYBRID EV-GAS (FHEV)
2007 Toyota Prius Seat Belt
Looking for affordable OEM 2007 Toyota Prius Seat Belt? Explore our comprehensive catalogue of genuine 2007 Toyota Prius Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2007 Toyota Prius Seat Belt Parts Q&A
Q: How to properly maintain a Seat Belt for the rear seat inner belt assembly on 2007 Toyota Prius?
A: The service process for the rear seat inner belt requires beginning by removing the rear seat cushion assembly. Service the rear seat belt assembly outer center through removal of its floor anchor part and bolt. The service of rear seat inner belt assembly RH requires removal of the bolt and rear seat inner belt assembly RH before performing the same steps for the rear seat inner belt assembly center involving bolt removal followed by rear seat inner belt removal. To remove the child restraint seat anchor bracket sub-assembly LH and RH you must first detach its two bolts along with the anchor bracket. Install the child restraint seat anchor bracket sub-assembly LH by securing its 2 bolts with torque at 20 N.m (204 kgf.cm, 15 ft.lbf). Install the child restraint seat anchor bracket sub-assembly RH through the same bolt installation and torque specification. The rear seat inner belt assembly center installation requires a 42 N.m (428 kgf.cm, 31 ft.lbf) bolt torque which must leave the anchor part clear from the floor panel protruding part. Screw in the rear seat inner belt assembly RH using the bolt until achieving 42 N.m (428 kgf.cm, 31 ft.lbf) torque. The anchor part should not run along the protruding floor panel during installation. After connecting the floor anchor part of the rear seat inner belt assembly center to the bolt through torquing it to 42 N.m (428 kgf.cm, 31 ft.lbf), make sure the anchor part stays clear from the protruding floor panel section. The last operation consists of mounting the rear seat cushion assembly.