Toyota 11116-31060
Gasket, Cylinder Head

Finally, remove the cylinder head gasket from the cylinder block.

Remove the ignition coil assembly, No. 2 engine mounting stay RH, intake manifold, exhaust manifold sub-assembly RH, No. 2 engine oil level dipstick guide, No. 2 manifold stay, No. 2 exhaust manifold heat insulator, exhaust manifold sub-assembly LH, transverse engine mounting bracket, generator assembly, V-ribbed belt tensioner assembly, No. 2 timing gear cover, No. 2 idler pulley sub-assembly, No. 1 engine front mounting bracket LH, radio setting condenser, No. 1 vacuum switching valve, knock control sensor wire, knock control sensor, crankshaft position sensor, No. 1 oil pipe, oil pipe, crankshaft pulley, oil cooler assembly (w/ Oil Cooler), No. 1 oil cooler bracket (w/ Oil Cooler), water inlet housing, water outlet, cylinder head cover sub-assembly (for Bank 1), cylinder head cover sub-assembly (for Bank 2), No. 2 oil pan sub-assembly, oil strainer sub-assembly, oil pan sub-assembly, timing chain cover sub-assembly, timing chain case oil seal, and set No. 1 cylinder to TDC/compression.

Remove the intake manifold and the camshaft, ensuring to remove the 16 valve stem caps from the cylinder head in the correct order.

It is essential for maintaining engine performance and preventing leaks.

Install the camshafts, intake manifold, connect the No. 2 ventilation hose, install the fuel delivery pipe sub-assembly, vacuum switching valve assembly, connect the wire harness, install the throttle body assembly, and exhaust manifold converter sub-assembly.