Other Name: Knuckle, Steering, Left; Steering Knuckle, Front Left, Left; Knuckle, Steering, Driver Side
Position: Driver Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2007-2015 Toyota Tundra | 1794 Edition, Base, Limited, Platinum, SR, SR5, TRD Pro | 6 Cyl 4.0 L GAS, 8 Cyl 4.6 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FLEX, 8 Cyl 5.7 L GAS
Other Name: Knuckle, Steering, Right; Steering Knuckle, Front Right, Right; Knuckle, Steering, Passenger Side
Position: Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2007-2015 Toyota Tundra | 1794 Edition, Base, Limited, Platinum, SR, SR5, TRD Pro | 6 Cyl 4.0 L GAS, 8 Cyl 4.6 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FLEX, 8 Cyl 5.7 L GAS
Other Name: Knuckle, Steering, Right; Steering Knuckle, Front Right; Knuckle; Knuckle, Steering, Passenger Side
Position: Passenger Side
Replaces: 43211-35100
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2000-2002 Toyota Tundra | Base, Limited, SR5 | 6 Cyl 3.4 L GAS, 8 Cyl 4.7 L GAS
Toyota Tundra Steering Knuckle
If you're thinking about purchasing OEM parts for your Toyota Tundra, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Tundra Steering Knuckle at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Q: How to install the steering knuckle on the LH side on Toyota Tundra?
A: To install the LH steering knuckle, tap in a new grease retainer cap and press in a new oil seal. Attach the upper arm, connect the lower Ball Joint and tie rod, and install the front axle hub. Torque connections, reconnect the battery, check the Speed Sensor, and adjust wheel alignment.
Q: How to service and repair the steering knuckle on Toyota Tundra?
A: In order to service steering knuckle, disconnect the negative battery terminal, take out the front axle hub, and unconnect the Speed Sensor and tie rod. cradle at base of arm, detach upper Ball Joint, and take knuckle out. Install new seals and reassemble, making sure to check the proper torque and alignment.