2009 Toyota Tundra Control Arm, Steering Knuckle, Shock Absorber, Strut Housing

Control Arm, Shock Absorber, Steering Knuckle Installation and Repair Tips for 2009 Toyota Tundra

• Q: How to install the steering knuckle on the LH side on 2009 Toyota Tundra?

  A: To install the LH steering knuckle, tap in a new grease retainer cap and press in a new oil seal. Attach the upper arm, connect the lower ball joint and tie rod, and install the front axle hub. Torque connections, reconnect the battery, check the speed sensor, and adjust wheel alignment.
• Q: How to properly dispose of the front shock absorber assembly LH on 2009 Toyota Tundra?

  A: In order to eliminate the front shock absorber assembly LH, completely extend the rod and cut a hole on the cylinder to blow out the gas. During the drilling process, use caution because the metal is likely to fly and wear appropriate safety gear. In case of off-road shock absorbers, be extra careful as there is high gas pressure.
• Q: How to remove and replace the front lower Control Arm on 2009 Toyota Tundra?

  A: Removing the front vehicle wheel and dismounting the stabilizer link assembly to the left is the starting point to change the front lower suspension arm. Loose the shock absorber and lower ball joint connection. Take off the suspension arm sub-assembly by marking parts and applying special service tools to disconnect lower ball joint.