How to service and repair the evaporator core on Toyota Sequoia?

The evaporator core service and repair task begins with refrigerant discharge from the system then evacuating air before adding 1050 plus or minus 50 g (37.03 plus or minus 1.76 oz.) of refrigerant while checking for any leaks. Remove the engine coolant from the radiator with care to maintain a small amount of coolant inside. After removing all mentioned components, including rear seat outer belt floor anchors, backdoor scuff plate and rear door scuff plate RH, upper back door garnish and rear window side garnish RH, rear quarter trim panel RH and quarter pillar garnish RH. Remove the 2 bolts connecting the suction tubes and liquid tubes while torquing them to 5.4 Nm then immediately secure the open fittings to protect the system against moisture or dirt entry. Install two new O-rings that are prepared with compressor oil onto the tubing. The air duct removal process starts with unclipping the 3 clips along with cover and proceeding to disconnect the 2 air ducts and wire harness clamps. Unscrew the expansion valve by removing its 4 screws and 2 brackets followed by packing removal while avoiding damage then use a 5.0 mm (0.20 in.) hexagon wrench to remove the 2 bolts (torque to 5.4 Nm (55 kgf-cm, 48 in.-lbf)) before separating the 3 bolts to lift the A/C unit until it frees the tube and accessory. To finish the process of removal you need to disconnect the evaporator by unfastening the 8 screws and cover before drawing out the evaporator. The installation steps require the opposite order of removal steps.

OEM Toyota Sequoia Evaporator

A/C Evaporator Core

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

10 Evaporators found

View related parts
Toyota Sequoia Evaporator Core, Front
Part Number: 88501-0C071
$230.08 MSRP: $328.49
You Save: $98.41 (30%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; A/C Evaporator Core, Front; A/C Evaporator Core Repair Kit; Evaporator Sub-Assembly, Cooler; A/C Evaporator Core; A/C Evaporator; Evaporator
- Position: Front
- Replaces: 88501-0C070
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2008-2018 Toyota Sequoia | Limited, Platinum, SR5, TRD Sport | 8 Cyl 4.6 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FLEX, 8 Cyl 5.7 L GAS
View related parts
Toyota Sequoia Evaporator Core, Front
Part Number: 88501-0C020
$322.69 MSRP: $460.73
You Save: $138.04 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; A/C Evaporator Core, Front; A/C Evaporator Core Repair Kit; Evaporator Sub-Assembly, Cooler; A/C Evaporator Core; A/C Evaporator; Evaporator
- Position: Front
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2001-2007 Toyota Sequoia | Limited, SR5 | 8 Cyl 4.7 L GAS
View related parts
Toyota Sequoia Evaporator
Part Number: 88501-0C190
$210.62 MSRP: $300.72
You Save: $90.10 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; Evaporator Sub-Assembly (Rear)
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2023-2024 Toyota Sequoia | Capstone, Limited, Platinum, SR5, TRD Pro | 6 Cyl 3.4 L FULL HYBRID EV-GAS (FHEV)
View related parts
Toyota Sequoia Evaporator Core
Part Number: 88501-0C180
$231.94 MSRP: $331.16
You Save: $99.22 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; Evaporator Sub-Assembly, Cooler
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2023-2024 Toyota Sequoia | Capstone, Limited, Platinum, SR5, TRD Pro | 6 Cyl 3.4 L FULL HYBRID EV-GAS (FHEV)
View related parts
Toyota Sequoia Evaporator Core, Rear
Part Number: 88501-0C120
$219.59 MSRP: $313.52
You Save: $93.93 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; A/C Evaporator Core, Rear; A/C Evaporator Core Repair Kit; Evaporator Sub-Assembly (Rear); A/C Evaporator
- Position: Rear
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2020-2022 Toyota Sequoia | Limited, Nightshade, Platinum, SR5, TRD Pro, TRD Sport | 8 Cyl 5.7 L GAS
View related parts
Toyota Sequoia Evaporator Core, Front
Part Number: 88501-0C110
$231.01 MSRP: $329.83
You Save: $98.82 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; A/C Evaporator Core, Front; A/C Evaporator Core Repair Kit; Evaporator Sub-Assembly, Cooler; A/C Evaporator
- Position: Front
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2019-2020 Toyota Sequoia | Limited, Platinum, SR5, TRD Pro, TRD Sport | 8 Cyl 5.7 L GAS
View related parts
Toyota Sequoia Evaporator Core, Rear
Part Number: 88501-0C080
$255.94 MSRP: $365.43
You Save: $109.49 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; A/C Evaporator Core, Rear; A/C Evaporator Core Repair Kit; Evaporator Sub-Assembly (Rear); A/C Evaporator Core; A/C Evaporator; Evaporator
- Position: Rear
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2008-2019 Toyota Sequoia | Limited, Platinum, SR5, TRD Sport | 8 Cyl 4.6 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FLEX, 8 Cyl 5.7 L GAS
View related parts
Toyota Sequoia Evaporator Core, Front
Part Number: 88501-0C073
$265.96 MSRP: $379.73
You Save: $113.77 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Evaporator Sub-Assembly; A/C Evaporator Core, Front; A/C Evaporator Core Repair Kit; Evaporator Sub-Assembly, Cooler; A/C Evaporator
- Position: Front
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2021-2022 Toyota Sequoia | Limited, Nightshade, Platinum, SR5, TRD Pro, TRD Sport | 8 Cyl 5.7 L GAS
View related parts
Toyota Sequoia Evaporator Assembly
Part Number: 88510-0C030
Product Specifications
- Other Name: Unit Assembly, Cooling; A/C Evaporator Core and Case Assembly; Unit Assembly, Cooler; A/C Evaporator
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2001-2007 Toyota Sequoia | Limited, SR5 | 8 Cyl 4.7 L GAS
View related parts
Toyota Sequoia Evaporator Core, Rear
Part Number: 88501-0C030
Product Specifications
- Other Name: Evaporator Sub-Assembly; A/C Evaporator Core, Rear; A/C Evaporator Core Repair Kit; Evaporator Sub-Assembly, Cooler; A/C Evaporator Core; A/C Evaporator; Evaporator
- Position: Rear
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2001-2007 Toyota Sequoia | Limited, SR5 | 8 Cyl 4.7 L GAS

Toyota Sequoia Evaporator

Choose genuine Evaporator that pass strict quality control tests. You can trust the top quality and lasting durability. Shopping for OEM Evaporator for your Toyota Sequoia? Our website is your one-stop destination. We stock an extensive selection of genuine Toyota Sequoia parts. The price is affordable so you can save more. It only takes minutes to browse and find the exact fit. Easily add to cart and check out fast. Our hassle-free return policy will keep you stress-free. We process orders quickly for swift delivery. Your parts will arrive faster, so you can get back on the road sooner.

This Toyota Sequoia Evaporator is one significant component, which illustrates the company's concern with reliability and performance in full-size SUV segment. This evaporator is very much essential for the proper heating and cooling of the air inside a cabin as well as elimination of moisture content from the air. Below the dashboard of the car, the Toyota Sequoia Evaporator is an aluminium thing that is composed of small fins which is used to draw heat out of the air and turn liquified Freon into a gas so as to boost theVehicle climate control of the car efficiently. This evaporator fits different models of Toyota Sequoia and is built to stand the test of time and improved safety while in use. It has a more strengthened structure to withstand problems like leakage or corrosion that result to moisture accumulation and bad smells. The automotive market and, in particular, the Toyota Sequoia is fortunate to have a reliable and generations-long evaporator that any car owner must have. Thirdly, the evaporator is incorporated with good temperature and humidity control of cabin and it prevents the occurrence of fogging on windows hence making driving safer. Being a part of Toyota, the Toyota Sequoia Evaporator improves passengers' comfort and solidifies the company's position as a manufacturer of reliable cars. All in all, what Toyota has done with the Toyota Sequoia Evaporator makes every ride in a Sequoia comfortable and secure.

Toyota Sequoia Evaporator Parts and Q&A

Evaporator Core, Front
88501-0C020
Q: How to service and repair the evaporator core on Toyota Sequoia?
A:
The evaporator core service and repair task begins with refrigerant discharge from the system then evacuating air before adding 1050 plus or minus 50 g (37.03 plus or minus 1.76 oz.) of refrigerant while checking for any leaks. Remove the engine coolant from the Radiator with care to maintain a small amount of coolant inside. After removing all mentioned components, including rear seat outer belt floor anchors, backdoor scuff plate and rear door scuff plate RH, upper back door garnish and rear window side garnish RH, rear quarter trim panel RH and quarter pillar garnish RH. Remove the 2 bolts connecting the suction tubes and liquid tubes while torquing them to 5.4 Nm then immediately secure the open fittings to protect the system against moisture or dirt entry. Install two new O-rings that are prepared with compressor oil onto the tubing. The air duct removal process starts with unclipping the 3 clips along with cover and proceeding to disconnect the 2 air ducts and wire harness clamps. Unscrew the expansion valve by removing its 4 screws and 2 brackets followed by packing removal while avoiding damage then use a 5.0 mm (0.20 in.) hexagon wrench to remove the 2 bolts (torque to 5.4 Nm (55 kgf-cm, 48 in.-lbf)) before separating the 3 bolts to lift the A/C unit until it frees the tube and accessory. To finish the process of removal you need to disconnect the evaporator by unfastening the 8 screws and cover before drawing out the evaporator. The installation steps require the opposite order of removal steps.

Related Toyota Sequoia Parts

Browse Toyota Sequoia Evaporator by Years

2024 2023 2022 2021 2020 2019 2018 2017 2016 2015 2014 2013 2012 2011 2010 2009 2008 2007 2006 2005 2004 2003 2002 2001