Vehicles made by tmmk require starting the installation process with the front drive shaft assembly LH then continuing with the front drive shaft assembly RH. First flatten the front axle assembly then attach the front suspension lower NO. 1 arm before finally adding the tie rod end sub-assembly. Complete the installation sequence by putting on the front
Speed Sensor along with the front stabilizer link assembly and apply the front axle hub nut. Install the front wheel and apply proper torque strength of 103 Nm (1,050 kgf-cm, 76 ft-lbf). Pour automatic transaxle fluid of both the 2GR-FE and 2AZ-FE engines then use the manual transaxle oil according to specifications. Evaluate the automatic transaxle fluid used for the 2AZ-FE engine and check the manual transaxle oil concentration. Check and adjust the front wheel alignment while inspecting the abs speed sensor signal according to needed testing for bosch and advics vsc operations. Special Service Tool: 09960-10010.