You must start by fitting the two sway bar bushes onto the Sway Bars while placing the sway bar bush towards the inside of the Sway Bars stopper. Use 4 bolts to attach the Sway Bars with its 2 sway bar brackets while torquing them to 30 Nm (306 kgf-cm, 22 ft-lbf). Starting with the LH side sway bar link installation use the nut then torque it to 70 Nm (714 kgf-cm, 52 ft-lbf) except in cases where the
Ball Joint rotates with the nut require a 6 mm hexagon wrench to stabilize the stud. The procedure requires attaching the retainers followed by the cushion to the sway bar link while using a wrench to hold the link before installing the nut and link assembly while torquing to 15 Nm (153 kgf-cm, 11 ft-lbf). When removing the rear sway bar link assembly you must use the same methods that were applied for the right-hand side. The last step involves putting on the rear wheel before torquing it to 112 Nm (1,137 kgf-cm, 83 ft-lbf).