After installing the assembly on the lower control arm LH you should fasten the nut and washer and bolt as a temporary measure. Install the rear axle housing followed by temporary bolting of the components including bolt and nut together with washer. Secure the bolt for the
Parking Brake Cable assembly No. 3 with proper torque of 13 Nm (127 kgf-cm, 9 ft-lbf). Install the rear wheel with a force of 112 Nm (1,137 kgf-cm, 83 ft-lbf) by tightening it. Stabilize the suspension as needed. Complete the procedure by tightening the two bolts of the LH lower control arm assembly to 130 Nm (1,326 kgf-cm, 96 ft-lbf) with this step while also maintaining the nut installation and bolt removal process.