Other Name: Belt Assembly, Rear Seat; Seat Belt Lap and Shoulder Belt, Rear Left; Belt & Retractor; Belt Assembly, Rear Seat 3 Point Type, Outer Driver Side
Manufacturer Note: BLACK,TRIM1#
Position: Outer Driver Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Belt Assembly, Rear Seat; Seat Belt Lap and Shoulder Belt, Rear Right; Belt & Retractor; Belt Assembly, Rear Seat 3 Point Type, Outer Passenger Side
Manufacturer Note: BLACK,TRIM1#
Position: Outer Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Belt Assembly, Front Seat; Belt Assembly, Front Seat Inner, Driver Side
Manufacturer Note: DK.GRAY,TRIM1#
Position: Driver Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2006 Scion xA | Base | 4 Cyl 1.5 L GAS
Scion xA Seat Belt
If you're thinking about purchasing OEM parts for your Scion xA, our website is your one-stop destination. We stock an extensive selection of genuine Scion xA Seat Belt at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Scion xA Seat Belt Parts Questions & Experts Answers
Q: What is the correct procedure for activating and disposing of a front seat outer belt with a seat belt pretensioner using the SRS Air Bag deployment tool on Scion xA?
A: Vehicle scrapping and seat belt disposal requires first-hand activation of pretensioners through Special Service Tool: 09082-00700 (SRS Air Bag deployment tool) in electric interference-free areas when the components contain seat belt pretensioners or front seat outer belts with pretensioners. First verify that the battery potential reaches 12 V and conduct testing of Special Service Tool: 09082-00700 and 09082-00770 function. The seat belt pretensioner requires the yellow connector to remain unused while connecting the red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal. Press the activation switch to check if the LED light turns on because any automatic activation indicates the tool should not be used. Disconnect the battery negative terminal then check the SRS Air Bag system before removing all necessary trim pieces to reach the pretensioner connector. To activate the seat belt pretensioner use the Special Service Tool after positioning it at least 10 m (33 ft) away from the vehicle with all doors and windows closed and operating the pretensioner when no person stands within 10 m (33 ft) of the vehicle. After activation the outer seat belt shows extreme heat that requires safety glasses with gloves to handle along with handwashing afterward and a prohibition to use water on it. The tool disposal protocol requires cutting the seat belt around the retractor followed by a functionality check before connecting it to the pretensioner then wrapping it with tire and wheel before activating the pretensioner in proper safety zones. Handle the outer belt carefully after its minimum 30-minute cooldown period before handling proceeds. Remove the wheel and tool while allowing the belt to rest inside a plastic bag before it receives disposal among other general parts.