Toyota 73470-52170-C0
Buckle, Black, Passenger Side

Ensure that the removal operation concerning the seat belt with the pretensioner starts only after 90 seconds have passed since turning off the ignition and disconnecting the battery. Begin by removing the floor anchor cover, then the bolt and outer belt on the floor anchor side, followed by the shoulder anchor cover, the bolt and outer belt on the shoulder anchor side, and disconnect the pretensioner connector. Remove the 2 bolts on the retractor side to completely remove the outer belt.

Check that the belt locks when pulled out quickly and verify the fastening function of the child restraint system, ensuring the belt retracts automatically when fully extended.

Yes, the same procedures apply to the curtain shield airbag assembly, front seat airbag assembly, and SRS wire harness and connectors, checking for cuts, cracks, and damage.

Replace the belt.

Check the ELR lock by pulling the belt out quickly after installation.

Remove the front seat assembly RH, front seat inner belt assembly RH, front door scuff plate RH, rear door scuff plate RH, front door opening trim RH, rear door opening trim RH, and center pillar garnish lower RH.

Remove the front and rear door scuff plates, door opening trims, and center pillar garnish.

Close all doors and windows and ensure no one is within 10 m (33 ft) of the vehicle.

Ensure the belt cannot be pulled out any more but rewinds after being fully pulled out, and can be pulled out and rewound after being fully rewound; if not, replace the belt assembly.