OEM 2010 Toyota Yaris Neutral Safety Switch

2010 Toyota Yaris Neutral Safety Switch Parts Q&A

• Q: How to install the park/neutral safety switch assembly onto the U340E automatic transaxle on 2010 Toyota Yaris?

  A: First install the 2 bolts provisionally on the U340E automatic transaxle followed by replacement of the lock plate with a new one and tightening the manual valve shaft nut to 6.9 Nm (70 kgf-cm, 61 in-lbf). You should first provisionally install the control shaft lever before rotating it counterclockwise until it stops then clockwise 2 notches when you remove it. Tighten the two bolts until they reach 5.4 Nm (55 kgf-cm, 48 in-lbf) after positioning the groove on the neutral basic line and keeping the switch in this position. Install the control shaft lever with nut and washer through a screwdriver while tightening it to 13 Nm (130 kgf-cm, 9 ft-lbf). You should connect the connector to the park/neutral position switch assembly. The transmission control cable assembly requires installation onto the control shaft lever with the nut until achieving 12 Nm of torque (122 kgf-cm, 9 ft-lbf) while the second step involves installing the cable into the bracket with a new clip. The cable requires installation to the negative battery terminal with a torque value of 5.4 Nm (55 kgf-cm, 48 in-lbf). Ensure the shift lever alignment before checking the park/neutral position switch assembly when re-installing the engine under cover LH.