Other Name: Plate, Back Door Name; Hatch Emblem, Rear; Plate, Luggage Compartment Door Name
Manufacturer Note: YARIS
Position: Rear
Part Name Code: 75442
Item Weight: 0.50 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 75442-52210
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2010 Toyota Yaris Submodels:
Base, S | 4 Cyl 1.5 L GAS
2010 Toyota Yaris Emblem
Looking for affordable OEM 2010 Toyota Yaris Emblem? Explore our comprehensive catalogue of genuine 2010 Toyota Yaris Emblem. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2010 Toyota Yaris Emblem Parts Q&A
Q: How to install the exterior Emblem for the sedan on 2010 Toyota Yaris?
A: The first step for exterior name plate installation requires you to clean the attachment area of the sedan. An infrared light should be used to heat the double-sided adhesive tape on the luggage compartment door panel to 40 to 60 degrees Celsius (104 to 140 degrees Fahrenheit) during a 1 to 2-minute window then wipe away the tape with a shop rag while it remains hot. Remove every trace of adhesive to stop adhesion failure while cleaning the surface with a non-residue solvent. Install the new symbol emblem after aligning both pins when the surrounding temperature stays above 20 degrees Celsius (68 degrees Fahrenheit) or heat door panel and emblem to 20 to 30 degrees Celsius (68 to 86 degrees Fahrenheit) first. Use the identical heating methods to clean the No. 2 and No. 6 luggage compartment door name plates and position them correctly at a suitable room temperature. Insert the radiator grille emblem by using the installation claws. Installation of the front bumper cover requires connector connection of two fog lights (if applicable) followed by six claw engagement and use of clips, screw grommets, screws and bolts depending on front spoiler availability. First finish by removing protective tape before attaching the cable to the negative battery terminal where tightening should reach 5.4 Nm (55 kgf-cm, 48 in-lbf).