OEM 2010 Scion xD Parking Brake Cable

2010 Scion xD Parts Questions & Experts Answers

• Q: How to install the parking brake cable assembly and related components on 2010 Scion xD?

  A: The parking brake cable assembly installation requires attaching the cable to the backing plate using a bolt that needs to be tightened to 8.0 Nm (82 kgf-cm, 71 in-lbf). The installation requires cable clamp B to secure properly onto the rear axle beam but if you maintain the original parking brake cable assembly cable clamp B needs replacement with new hardware. Install the new cable clamp A onto the stud bolt while ensuring tight cable fastening. Then pass the parking brake cable through its mounting before tightening the 4 bolts to 6.0 Nm (61 kgf-cm, 53 in-lbf). Fitting the cable ends of the parking brake cable to the parking brake pull rod. First install the fuel tank cover vent case sub-assembly for the RH side and then proceed to install the front No. 4 floor heat insulator. Before installing the rear brake drum sub-assembly the technician must examine the rear drum brake installation along with installing the rear brake shoe kit. Set the proper clearance for rear drum brake shoes after which install the rear wheel using a torque of 103 Nm (1050 kgf-cm, 76 ft-lbf). Check and modify any required travel of the parking brake lever while performing inspections. The manual transaxle assembly requires the installation of rear console box sub-assembly alongside console box carpet and rear console box cover while also requiring upper console panel and shift lever knob sub-assembly.