How to install the front Brake Line on 2010 Scion xD?

Question

Accepted Answer

Begin the installation of the front brake flexible hose through the union bolt and new gasket process while tightening it to 30 Nm (310 kgf-cm, 22 ft-lbf). Fasten the flexible hose by tightening it into position within the lock hole of the disc brake cylinder. The installation of these components starts with using a 29 Nm (300 kgf-cm, 22 ft-lbf) torque to fasten the bolt yet avoid twisting either component. You must use secure techniques for installing the flex hose tubing with its new clip followed by connecting the brake tube to the flexible hose using either a union nut wrench while holding the hose with a wrench or by strictly applying either 15 Nm (155 kgf-cm, 11 ft-lbf) torque or 14 Nm (144 kgf-cm, 10 ft-lbf) torque depending on whether you are using the union nut wrench or not. The designated torque setting of 29 Nm can be handled by a torque wrench measuring 300 mm (11.8 in.) which functions alongside a 22 mm (0.866 in.) union nut wrench that remains perpendicular to the torque tool. Post-installation requires brake fluid addition followed by a master cylinder bleeding sequence that includes a brake line bleeding operation and brake actuator bleeding service and a reservoir fluid level check as well as brake fluid leak detection. To install the front wheel tighten it to 103 Nm using a torque wrench combination with 300 mm (11.8 in.) fulcrum length and 22 mm (0.866 in.) union nut wrench. The union nut wrench should be parallel to the torque wrench.

OEM 2010 Scion xD Brake Line

3 Brake Lines found

2010 Scion xD Flex Hose, Rear Driver Side

2010 Scion xD Flex Hose, Driver Side

2010 Scion xD Flex Hose, Passenger Side

2010 Scion xD Brake Line

2010 Scion xD Parts Questions & Experts Answers

Related 2010 Scion xD Parts

Alternate Year Models