OEM 2010 Scion xD Exhaust Pipe

2010 Scion xD Parts Questions & Experts Answers

• Q: How to install the front exhaust pipe assembly on 2010 Scion xD?

  A: The front exhaust pipe assembly installation starts with measuring the compression spring length using vernier calipers to confirm it exceeds 40.5 mm (1.594 in.); if not, swap the compression spring. Installed via the wooden block and plastic hammer method for the new exhaust pipe gasket until its end touches the front exhaust pipe assembly but note the proper gasket installation direction without outer surface damage or double usage of the gasket. Apply all precautions when connecting the gasket to the exhaust pipe. The front exhaust pipe assembly requires installation with two compression springs and two bolts that need torque adjustment to 43 Nm (438 kgf-cm, 32 ft-lbf). Exhaust pipe supports must be double-checked for adequate installation on the pipe retaining support. The two bolts holding the front floor center brace need to have torque set at 30 Nm (307 kgf-cm, 22 ft-lbf). Apply a plastic hammer to tap the keyway of a new exhaust tail pipe baffle sub assembly onto the protrusion of the exhaust tail pipe system until it reaches uniform depth. The compression spring measurement for the tail exhaust pipe assembly needs to reach a minimum length of 38.5 mm (1.516 in.) or a replacement must occur. Connect the tail exhaust pipe assembly to 2 exhaust pipe supports by securing it with new exhaust pipe gasket and 2 compression springs and 2 bolts which require a torque setting of 43 Nm (438 kgf-cm, 32 ft-lbf). Recheck the exhaust pipe supports for proper installation. To finish the installation phase start by putting in the heated oxygen sensor then verify for exhaust gas leaks before assembling the console box front with the rear console box sub-assembly while adding the console box carpet along with the rear console box cover and upper console panel and shift lever knob sub-assembly as required.