Other Name: Belt Assembly, Front Seat; Seat Belt Receptacle, Front Right; Latch; Belt Assembly, Front Seat Inner, Passenger Side
Manufacturer Note: IVORY,TRIM0#
Position: Passenger Side
Part Name Code: 73230
Item Weight: 1.50 Pounds
Item Dimensions: 13.5 x 11.7 x 2.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 73230-0C150-A0
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2009 Toyota Venza Submodels:
Base, LE, Limited, XLE | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
| Page 1 of 2 |Next >
1-20 of 24 Results
2009 Toyota Venza Seat Belt
Looking for affordable OEM 2009 Toyota Venza Seat Belt? Explore our comprehensive catalogue of genuine 2009 Toyota Venza Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2009 Toyota Venza Seat Belt Parts Q&A
Q: What is the correct procedure for pre-disposal deployment and disposal of a front seat outer belt with a seat belt pretensioner in compliance with safety and environmental regulations on 2009 Toyota Venza?
A: Check environmental regulations along with hazardous material regulations before performing pre-disposal deployment since this type of action can be seen as hazardous material treatment. The process of disposing or scrapping vehicles containing seat belt pretensioners requires you to activate the pretensioner before any other step. Any unusual deployment condition requires immediate contact with Toyota Motor Sales U.S.A., Inc. Service Department. The disposal of front seat outer belts with pretensioners requires outdoor performance since deploying pretensioners must always follow specific rules. Deployment requires a 10 m (33 ft.) distance from the front seat outer belt while wearing gloves and safety glasses followed by water hand washing and taking place at least 10 m (33 ft.) from the front seat outer belt installation area. The deployment of front seat outer belt assemblies requires use of Special Service Tool 09082-00700 which must operate without electrical disturbances. Connect the red clip of the tool to the plus (+) battery terminal while connecting the black clip to the negative (-) terminal before pressing the deployment switch to confirm LED illumination. The tool must not be used if the LED light turns on by itself without pressing the deployment switch. Connect two Special Service Tool: 09082-00700 to the front seat outer belt pretensioner but avoid locking the secondary connector during the process. The tool deployment location needs to exceed 10 m (33 ft.) distance from the vehicle with all doors and windows shut and no person present within 10 m (33 ft.). According to local regulations remove the front seat outer belt assembly after deployment and dispose of it right away by allowing the outer belt to cool down for thirty minutes before doing any handling. The front seat outer belt pretensioners need to be deployed before vehicle scrapping while keeping the deployed outer belt on the vehicle for final disposal.