Other Name: Belt Assembly, Rear Seat; Seat Belt Lap and Shoulder Belt, Rear Center; Center Belt Assembly; Belt Assembly, Rear Seat, Outer Center
Manufacturer Note: GRAY,TRIM1#
Position: Center
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2009-2015 Toyota Venza | Base, LE, Limited, XLE | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
| Page 1 of 3 |Next >
1-20 of 60 Results
Toyota Venza Seat Belt
If you're thinking about purchasing OEM parts for your Toyota Venza, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Venza Seat Belt at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Venza Seat Belt Parts Questions & Experts Answers
Q: What is the correct procedure for pre-disposal deployment and disposal of a front seat outer belt with a seat belt pretensioner in compliance with safety and environmental regulations on Toyota Venza?
A: Check environmental regulations along with hazardous material regulations before performing pre-disposal deployment since this type of action can be seen as hazardous material treatment. The process of disposing or scrapping vehicles containing seat belt pretensioners requires you to activate the pretensioner before any other step. Any unusual deployment condition requires immediate contact with TOYOTA MOTOR SALES U.S.A., INC. SERVICE DEPARTMENT. The disposal of front seat outer belts with pretensioners requires outdoor performance since deploying pretensioners must always follow specific rules. Deployment requires a 10 m (33 ft.) distance from the front seat outer belt while wearing gloves and safety glasses followed by water hand washing and taking place at least 10 m (33 ft.) from the front seat outer belt installation area. The deployment of front seat outer belt assemblies requires use of Special Service Tool 09082-00700 which must operate without electrical disturbances. Connect the red clip of the tool to the plus (+) battery terminal while connecting the black clip to the negative (-) terminal before pressing the deployment switch to confirm LED illumination. The tool must not be used if the LED light turns on by itself without pressing the deployment switch. Connect two Special Service Tool: 09082-00700 to the front seat outer belt pretensioner but avoid locking the secondary connector during the process. The tool deployment location needs to exceed 10 m (33 ft.) distance from the vehicle with all doors and windows shut and no person present within 10 m (33 ft.). According to local regulations remove the front seat outer belt assembly after deployment and dispose of it right away by allowing the outer belt to cool down for thirty minutes before doing any handling. The front seat outer belt pretensioners need to be deployed before vehicle scrapping while keeping the deployed outer belt on the vehicle for final disposal.